|
螺栓尾部的凸度
Protrusions of bolt ends
参考页数：6P.;A4
|
|
|
|
|
|
ISO通用米制螺纹. 第51部分:过渡配合用外螺纹 (模型:紧密配合用螺纹); 公差, 极限偏差, 尺寸极限
ISO general purpose metric screw threads - Part 51: External screw threads for transition fits (former: screw threads for interference fit); tolerances, limit deviations, limits of sizes
参考页数：17P;A4
|
|
|
|
|
|
轴环连接 多边形轮廓P4C 第2部分:计算和定尺寸
Shaft to collar connection - Polygon profile P4C - Part 2: Calculation and dimensioning
参考页数：8P;A4
|
|
|
|
|
|
非螺纹密封的管螺纹. 第1部分: 尺寸, 公差和标识. 尺寸限制; 英文版本DIN EN ISO 228-1附件1: 2003-05
Pipe threads where pressure-tight joints are not made on the threads-part 1:dimensions,tolerances and designation-limits of size; English version of DIN EN ISO 228-1 Supplement 1:2003-05
参考页数：4P.;A4
|
|
|
|
|
|
T型头螺栓用的T型槽
T-slots for T-head bolts
参考页数：5P;A4
|
|
|
|
|
|
有内螺纹的锥形轴端.尺寸
Conical shaft ends with internal thread; dimensions
参考页数：2P.;A4
|
|
|
|
|
|
带外螺纹的锥形轴端.第1部分:尺寸
Conical Shaft Ends with External Thread; Dimensions
参考页数：3P.;A4
|
|
|
|
|
|
ISO通用公制螺纹.公差.第4部分:与由镀锌后公差位置为H或G攻丝的内螺纹相匹配的热浸镀锌外螺纹的尺寸限制 (ISO 965-4:1998)
ISO general purpose metric screw threads - Tolerances - Part 4: Limits of sizes for hot-dip galvanized external screw threads to mate with internal screw threads tapped with tolerance position H or G after galvanizing (ISO 965-4:1998)
参考页数：6P.;A4
|
|
|
|
|
|
用螺桩、铆钉螺桩连接的角形连接件
Angle joints with screw studs, with rivet studs
参考页数：3P.;A4
|
|
|
|
|
|
轴环连接 多边形轮廓P3G 第2部分:计算和定尺寸
Shaft to collar connection - Polygon profile P3G - Part 2: Calculation and dimensioning
参考页数：8P.;A4
|
|
|
|
|
